ways to finish deck boards edges

If you install capped composite decking, you know how unsightly the ends of the boards are compared with the capped tops, bottoms, and edges. One way to hide the ends is to install a boards, borders are almost a distraction. An alternative is to finish the decking with a 3 8- to 1 2-inch-wide trim detail.

In this final video of our how to build a deck series we'll show you how to add accessories and give your deck a custom look with a lot of personality. Upgrade Your Deck and Add Finishing Touches. Whether you just completed a . and end joists. When the boards are in place, add a fascia board to cover the deck edges.

Install a picture frame or perimeter board to finish the edge of your deck with style. An effective method of finishing a deck surface is to install a trim board around the perimeter of the deck. Be sure to consider how your rail system will be attached and how your rail posts will intersect with surrounding decking. Support for

Use a traditional board when finishing a deck and cut out notches for the four-by-four posts on each end of the built deck. Cut and measure wood correctly wh

Right: Rip a treated 2 x 2 (1-1 2-by-1-1 2-inch), then use a router with a round-over bit to shape the rounded edges. Left: Then round the ends on a bandsaw or disc sander for a further finished look. Right: 5 4-inch deck boards added as siding creates an unusual look to close off the sides of a step. Steps.

That way you get a cleaner and more even edge than if you were trying to measure and cut each board independently and then placing them all. at) and then finished down the line, stopping before I got to my last board (which is part of the “picture frame” design, so it was already pre-mitered before I

Check out this useful How To from Ultimate Handyman on How To Make A Picture Frame Deck. I like the way they finished the edges grey type decking material. The Becks created a "picture frame" effect and stained those boards with a darker color of Thompson's Water Seal Deck & House Solid Latex Stain.

Measure the perimeter of your deck to determine how much extra material you will need for the fascia. Cut the boards so they fit snugly around the base of the deck. If you like, leave a small lip underneath the deck's surface. Some homeowners even finish off the deck edge with bullnose trim. Attach the boards to the rim

My first choice would be to see if you can get a wider deck board (~7.25") and then rip that to the appropriate width. If it's the first board above the stairs, expect it to see a lot of traffic. Of the two you mention, I'd go with Option A. I would join the two pieces together, rather than leave a gap (because there's not